Make | Model | Problem | Solution | Date |
| | | |
Found: 686
|
Aiwa | C202KER | Field collapse | Fusible link 1500 marked as jumper lead from loptx to reg via D6813 | 14-09-04 |
Aiwa | TVC211 | St/by only | Replace EEPROM & R617 - the cause - which goes hi res | 14-09-04 |
|
Ferguson | DFS68NX IDC2 | Pic gradually goes bright with fb lines then trips | RT06 1M under A1 pot o/c | 14-09-04 |
Ferguson | IDC2 | No sound | 4 smd transistors on the audio pcb TS40,41,42,43. | 14-09-04 |
Ferguson | IDC2 | No sound | Transistors TS40/41/42/43 BC848/857s in mute cct | 14-09-04 |
Ferguson | IDC2 DSF68N | Int comes on or reverts to AV2 | TX26 BC858B sm | 14-09-04 |
Ferguson | IDC2 DSF68N | No mono sound | EEPROM | 14-09-04 |
Ferguson | IDC2 DSF68N | No sound - pic ok | TS40 BC857 in audio mute cct | 14-09-04 |
Ferguson | IDC2 DSF68N | Sound int | Audio muted - pin 4 Plug BS80 high - TS41 BC857B faulty | 14-09-04 |
Ferguson | IKC2 | blows chopper trs | CP29 2n2 in snubber network - swollen at leg | 14-09-04 |
Ferguson | IKC2 | Bright pic | RL05 100k o/c | 14-09-04 |
Ferguson | IKC2 | Dead | Check for 21V at emitter TP18 if low check DP16 for s/c ( IN4148 ) | 14-09-04 |
Ferguson | IKC2 | DEAD ( STARTS BUT SHUTS DOWN ) LISTEN FOR LACK OF | IF01B TLO82 , AND TF16 | 14-09-04 |
Ferguson | IKC2 | Dead - CL44 in line s/c - blew S2000 loptr | Fusible in 220v supply to RGB o/p stage o/c | 14-09-04 |
Ferguson | IKC2 | Dead - emitter of TP18 below 21v. | Check DP16 ( 1N4148 ) s/c. | 14-09-04 |
Ferguson | IKC2 | Dead - trips at sw on | TV01 BC558 leaky caused by arcing loptx | 14-09-04 |
Ferguson | IKC2 | Dead, st/by ok | TV01- attenuating drive o/p from line driver | 14-09-04 |
Ferguson | IKC2 | Field collapse | TF25, a BC548, in the field ramp generator which was s/c caused by loptx arcing. | 14-09-04 |
Ferguson | IKC2 | Field foldover | DF16 ( BY398 ) leaky | 14-09-04 |
Ferguson | IKC2 | Frame foldover. | DF16 ( BY398 ) leaky. | 14-09-04 |
Ferguson | IKC2 | GOES STRAIGHT TO STBY | IFO1 SC DF16 SC | 14-09-04 |
Ferguson | IKC2 | Going in to standby after few Seconds. | DL11 ( BA157 ) s/c , RL11 ( 15ohm ) o/c LH side of LOPTX. | 14-09-04 |
|
Ferguson | IKC2 | H.T. correct at switch on with no line output oper | Check pin 40 IV01 ( T8659 ) 9V = on 0V = StBy trip Volts come from TR17 maybe o/c | 14-09-04 |
Ferguson | IKC2 | Int st/by aft long time | TV01 BC558C & TV02 BC548C transistors | 14-09-04 |
Ferguson | IKC2 | Low brightness - doesn't alter with OSD | TT33 on crt base | 14-09-04 |
Ferguson | IKC2 | No results no standby LED. | DP50 ( BY399 ) o/c. | 14-09-04 |
Ferguson | IKC2 | No startup. | TR16 ( BC548B ) , TR17 ( BC558B ) | 14-09-04 |
Ferguson | IKC2 | Off with bang | mains fuse shattered, on/off sw siezed - caused by degaus positor | 14-09-04 |
Ferguson | IKC2 | St/by only aft brief rush of EHT | IF01 TL082 field dr chip faulty - no pulses coming out - only dc which turned fop thy hard on | 14-09-04 |
Ferguson | IKC2 | Standby - Locked in Standby. | Press Programme Up button on front unit for 6 seconds. | 14-09-04 |